Pecho de res ahumado estilo competencia

Directions

1. Remove excess fat from bottom of brisket – trimming to approximately ¼” of fat across the brisket. The goal is to get the brisket to rest evenly and flat. Trim off any thin areas along the edges as well, as these will quickly become overdone.

2. When the cook is complete you are going to need to slice the brisket against the grain of the meat to prevent your meat from being too tough. A simple hack to remember where to cut is to slice off a corner of the brisket, against the grain, as if you were going to slice the entire piece of meat. The grain will be tougher to see when the cook is complete, and this starting cut will help guide you.

3. Prepare the brisket injection by heating ingredients together to fully combine. Allow this mixture to completely cool prior to injecting. 

4. Inject the mixture at a 45° angle with the needle pointing with the grain of the meat. Push the needle almost completely through the meat and depress the injector while slowly withdrawing. Injecting in this manner allows the injection to flow along the grain of the meat and through the entire thickness. Using a grid pattern and tightening the space between your injection points is a common practice. ¼” – ½” between injection points is typical. 

5. Once fully injected use your hands to massage the meat and push the injection throughout the meat. 

6. Coat all exposed meat with Grillmeister’s Beef Rub. Wrap brisket tightly with plastic wrap and place in refrigerator overnight, or at least for a couple of hours minimum.

7. For the true competition experience, wake up by 3am, stumble outside with a flashlight, scare away the neighborhood racoons, and light your fire. Competition etiquette allows for sleeping in a camp chair while cooking, just be sure to set your alarm so you don’t overcook that brisket or miss the turn-in time.

8. Heat grill to 275°-300°. Add Hickory, Oak, or Mesquite wood chunks, depending on the flavor you wish to achieve. Oak will be a traditional smoke flavor, Hickory will be sweeter, and Mesquite earthy and rich. 

9. Remove brisket from plastic wrap and add additional rub as needed so meat is covered evenly. 

10. Place brisket on grill and cook until the color is a rich mahogany and the internal temperature is 145°-150°. Wrap the brisket tightly in foil and add the braising liquid.  Be sure to seal the edges of the foil to retain all liquids during the cook (double wrap if you have thin foil, or place brisket in a foil pan and cover tightly). Return the brisket to the grill.

11. The trickiest part of cooking a brisket is knowing the precise time to pull it so it isn’t tough or isn’t too soft. Most briskets will be perfectly done when the internal temperature of the thickest part of the brisket is 205°-208°. The probe of a thermometer should glide into the brisket as if it is gliding into a room temperature block of butter. There should be some resistance, but not very much. Be sure to insert the probe against the grain of the brisket to accurately gauge the tenderness. Some briskets may be done at lower temperatures while others may be perfectly tender at higher temperatures.  Each cut of meat is different and it’s important to gauge the doneness of your meat by feel, rather than a precise finished temperature.  This may take practice, but eventually anyone can figure out that perfect brisket feel once they’ve achieved it a time or two.

12. Once done, pull the brisket and allow it to rest wrapped in foil for at least 30 minutes. It can be held longer by placing it in a clean, dry cooler to retain the heat. 

13. Remove the brisket from the foil and save the remaining juice. Use a fat separator to separate the au jus of the brisket from the bitter fat. 

14. Slice the brisket against the grain (using your docked corner you cut prior to cooking) about the width of a pencil. If the brisket is overcooked, slicing in thicker slices can help combat this. Alternatively, if the brisket is undercooked, slicing thinner slices will help. Brisket is perfectly done when it holds together, but snaps in half when pulling on the slice with little effort. 

15. Place the slices in a pan with the au jus (discarding the fat that has risen to the top of the separator). Separate the slices and allow them to soak up the moisture from the au jus. 

16. Serve hot. In a non-competition setting the remaining au jus can be served as a dipping sauce with the brisket.